Hana DNA40 Clone: Features, Performance, and Value

The Hana DNA40 clone refers to a box-style vape mod that copies the look and function of the original Hana Modz DNA40 device. It uses a DNA40-style chip to control power and temperature, and it usually sells for much less.

It aims to match the DNA40 experience, including temperature control, at a lower cost.

Buyers should compare build quality and safety features before choosing one. A clone's chip may not be a genuine Evolv board, and that affects accuracy and protection.

Key Takeaways

It is a clone version of the Hana DNA40 vape mod
The genuine Evolv DNA40 chip runs 1 to 40 watts, with temperature control for Ni200 nickel wire only
Quality, and whether the chip is genuine, vary by manufacturer

Key Features and Technical Aspects of the Hana DNA40 Clone

The Hana DNA40 clone focuses on temperature control, stable power output, and a familiar box mod layout. It uses a DNA40-style chip and follows many of the design choices found in the original Hana Modz DNA40.

DNA40 Chipset Overview

The clone uses a DNA40-style chipset based on Evolv's DNA40 design. The genuine Evolv DNA40 is rated for 1 to 40 watts and has a small 128×32 OLED screen.

Some clones use a true DNA40 chip, while others use a copied or compatible board. A copied board may not match Evolv's accuracy or protections, so ask the seller which one you are getting.

The DNA40 focuses on temperature protection rather than high wattage. The 40 watt chip suits vapers who prefer control over raw power.

Temperature Control and Protection Technology

Temperature control is the main reason many users choose a Hana DNA40 clone. The genuine DNA40 supports temperature control with Ni200 nickel wire only. It reads the coil's change in resistance to limit its temperature, which helps prevent dry hits and burned wicks.

The chip's temperature range is 200 to 600°F (93 to 315°C). Kanthal, titanium and stainless steel builds are not supported for temperature control on the DNA40 and only work in wattage mode.

Evolv lists low resistance, short circuit, overheat and low voltage protection for the genuine chip. A clone board may not include all of these, which is a key reason to buy carefully.

Wattage and Output Performance

The DNA40 supports wattage control up to 40 watts. That range suits single-coil builds and moderate airflow tanks.

Evolv lists synchronous rectification on the DNA40 for better battery life and less heat, plus coil preheat. The chip adjusts voltage (1 to 9 volts) to hold the set wattage as the battery drains.

Check the battery type before you buy, since clone layouts differ. Use an authentic, high-drain cell, and keep builds within the resistance range your board supports.

Build Quality and Components

Build quality varies between manufacturers. The shape follows the original Hana Modz box design.

Most use a spring-loaded 510 connector. Internal wiring and soldering quality depend on the maker, and better clones use thicker wires and cleaner solder joints.

The battery sled often uses plastic with metal contacts. Buttons may feel firm or soft depending on the model. Screen brightness and fire button response also vary between units.

Safety Tips

Charge with the cable or charger recommended for the device, and never use a damaged battery. The FDA says to replace batteries that get damaged or wet and to store loose batteries in a case.