Deviate DNA40 Mod: Features and Performance

The Deviate DNA40 mod is an older box mod built around Evolv's DNA 40 chip. That chip was one of the early mainstream boards with temperature control, which is why vapers still ask about it.

The Deviate DNA40 uses the Evolv DNA 40 board, which offers up to 40 watts of output and temperature control with Ni200 nickel coils. It is an older device: Evolv now lists the DNA 40 under its old products.

We could not find an official manufacturer page for the Deviate itself, so the specs below come from Evolv's DNA 40 page. Details such as the chassis material and battery type should be checked on the unit you are buying.

Key Takeaways

The Deviate DNA40 uses Evolv's DNA 40 chip: 1 to 40 watts, with temperature control for Ni200 nickel.
It helped bring temperature control to everyday vapers.
It is an older device, so expect to find it secondhand rather than new.

Deviate DNA40 Mod: Features, Design, and User Experience

The Deviate DNA40 mod uses the Evolv DNA40 board, which delivers up to 40W of power with temperature control. It has an OLED display and on-device buttons for settings.

Key Specifications and Internal Hardware

According to Evolv's DNA 40 spec page, the board offers a wattage range of 1 to 40W and a voltage range of 1 to 9V. It supports both standard wattage mode and temperature control.

Check whether your unit takes a single 18650 battery or another cell before you buy batteries. We could not confirm the Deviate's battery setup from a manufacturer page.

The DNA 40 drives a 128 x 32 OLED screen and includes coil preheat. Evolv lists low resistance, short circuit, overheat and low voltage protection. Any standard 510 tank or dripper can be fitted, as long as its coil suits the board's limits.

Temperature Control Capabilities and Coil Compatibility

The DNA 40's temperature control supports Ni200 nickel wire only. Nickel's resistance changes predictably as it heats, which lets the board limit coil temperature.

Evolv lists a temperature range of 200 to 600°F (93 to 315°C). Limiting coil temperature helps prevent dry hits and burnt wicks.

Kanthal and other wires that don't change resistance much with heat run in wattage mode instead. Newer chips added support for titanium and stainless steel, but the DNA 40 does not list them.

Chassis Construction and Aesthetic Influence

We could not verify the Deviate's chassis material, dimensions or design details from an official source.

If you're buying one secondhand, check the battery door, 510 connection and buttons for wear. Make sure the screen and firing button work before you buy.

User Interface and Operation Modes

The DNA 40 uses onboard buttons for firing and adjustments, with settings shown on the OLED screen. Temperature control only works with Ni200 coils, so use nickel if you want it.

Because this is an older device, follow the FDA's vape battery tips: use only batteries recommended for the device, and charge on a clean, flat surface where you can see it.