Moloch Mechanical Mod Clone Review And Performance Insights

The Moloch Mechanical Mod Clone is a lower-cost copy of the Moloch, an unregulated tube mod. It appeals to people who like mechanical simplicity and a mod with no chip or screen.

A mechanical mod gives direct battery output, and its reliable power output depends entirely on clean contacts and good batteries. It has no electronic protection, so it is only for experienced users who understand battery safety.

Key Takeaways

The Moloch clone is an unregulated mechanical mod with no protection circuit.
It costs less than an original, but build quality varies between clone makers.
Safe use depends on authentic high-drain batteries and coils matched to their limits.

Moloch Mechanical Mod Clone Overview

The clone copies the look and layout of the original Moloch tube mod. We could not find an official spec page for the original, so details such as battery size and dimensions should be checked on the unit you buy.

Key Features and Design

Clones are typically made from brass, copper or stainless steel. Brass and copper conduct electricity better than stainless steel, which can lower voltage drop.

Its tube design holds the battery in line with the atomizer. Check which cell size your clone accepts before buying batteries.

The fire button may use a spring or magnets. Look for a locking ring or recessed button, since a mech that fires in a pocket can overheat the battery and the atomizer.

Some clones have adjustable contacts to remove battery rattle. A loose battery causes intermittent contact and arcing, which wears the contacts and can be unsafe.

Performance and Safety Considerations

Because the Moloch clone is a mechanical mod, it has no regulation or protection circuits. Follow battery safety rules every time you build or swap batteries.

Use authentic high-drain cells and check their continuous discharge rating (CDR) in amps. A fully charged single cell at 4.2V on a 0.15 ohm coil draws about 28 amps, more than many cells are rated to supply.

If your version holds two batteries in series, voltage roughly doubles and so does the current through the same coil. Series builds need much higher resistance and a matched pair of cells.

The FDA advises never mixing battery brands, charge levels, or old and new batteries, and replacing damaged or wet batteries.

Vent holes help release gas if a battery fails, but they do not prevent failures. Always measure each build with an ohm reader before firing, and replace cells with torn wraps.

Output falls as the battery drains, because there is no chip to hold power steady. Recharge before the vape turns weak rather than running cells flat.

Comparison With Authentic Moloch and Other Clones

Original mods are generally made in smaller batches with tighter machining and better plating. Clones come from larger production runs, and quality varies by batch and maker.

With clean contacts and threads, a good clone works much like the original electrically. Cheaper clones may have rough threads, soft springs or poor insulators.

Clone users should inspect threads, contacts and insulators regularly. Stop using any mech that gets hot while not firing or fires on its own.

Compatible Atomizers and Accessories

The Moloch clone works with rebuildable dripping atomizers (RDAs) and rebuildable tank atomizers (RTAs) with a standard 510 connection. Check the tube's diameter before choosing an atomizer.

If your clone uses a hybrid top cap, where the atomizer pin presses directly on the battery, the atomizer must have a protruding, insulated positive pin. A flush pin on a hybrid connection can cause a direct short.

Spare springs, magnets and O-rings help keep the mod working. A multimeter or ohm reader is an essential accessory for any mechanical mod user.

In the US, it is illegal for retailers to sell any tobacco product, including vapes, to anyone under 21.